AEG DDLE EASY Electronic Instantaneous Water Heater, 21 kW, White

High temperature comfort: Instant and unlimited hot water at one or more water points in apartments and single-family homes, e.g. wash basin, shower, kitchen sink and bathtub. Largely constant water temperature: temperature setting with application symbols shower 42°C, kitchen sink 55°C. Easy installation: Flexible above or below table mounting, remote or direct tapping, for pressure (closed) fittings. AEG DDLE EASY electronic instantaneous water heater 21kW white Maximum temperature comfort Supply your entire house or apartment with hot water in an energy-saving and low-effort manner: simultaneous supply of the washbasin, shower, kitchen sink and bathtub (from an output of 21 kW) Easy installation Elegant, narrow instantaneous water heater for supplying one or more nearby water points for above or below-table installation: Requirement: pressure (closed) connection: fixed connection, cold water connection, Pressure fitting, water jet protection IP25 Special accessories: Under-sink mounting kit UT 104 (moves the water connections to the top of the device and thus enables under-sink installation) The installation of non-plug-in devices must be carried out by the respective network operator or by a registered specialist company, who will also help you obtain the consent of the respective network driver for the installation of the device. Technology at its finest Two fixed temperatures 42°C and 55°C with application symbols For high temperature stability, fast control electronics Bare wire heating system that is insensitive to calcification Note: A 400 V high-voltage connection (three-phase alternating connection) is required to install this device. The assembly (water and electrical installation) as well as the initial commissioning and maintenance of this device may only be carried out by a qualified electrician in accordance with the applicable regulations and in accordance with these instructions. A three-phase AC connection (high power connection) is required to operate this device. For devices with a nominal output of more than 12kW, the consent of the respective network operator must be available or obtained before initial installation. The device may only be installed with the consent of the network operator by the network operator itself or by an installation company that is registered in the installer directory of a network operator.