AEG small instantaneous water heater 3.5kW MTH 350

Small instantaneous water heater for supplying lukewarm water for the hand basin in the guest toilet (not suitable for shower or bathtub) Temperature increase up to 25°C possible, outlet temperature dependent on inlet temperature, flow rate internally adjustable approx. 2.0l/min., good water distribution thanks to the jet regulator supplied. Simple and space-saving installation: flexible above or under-table installation, only suitable for low-pressure (open) fittings, ready to plug in AEG hydraulic Small instantaneous water heater Supply water points with hot water in an energy-saving manner and with little effort: for supplying a hand basin in the weekend house, guest toilet and toilet facilities. If higher amounts of water and temperatures are required (e.g. sink in the kitchen), small storage tanks (85°C) or instantaneous water heaters (60°C) with an output of 12 kW or more should be used. For showering, an instantaneous water heater with an output of 18kW or more or a wall-mounted hot water tank is required. Small, stylish instantaneous water heater for supplying a hand basin for installation under or above the table. Requirement for: Low pressure (open) connection: Schuko socket with 16 A fuse, cold water connection, low pressure fitting Special jet regulator: Small amounts of water in the watercourse are well distributed using the jet regulator supplied and a good, soft jet pattern is created. The installation of non-plug-in devices must be carried out by the respective network operator or by a registered specialist company who will also help you obtain the consent of the respective network driver for the installation of the device. Important note: The device may only be installed with a low-pressure (open/unpressurized) fitting without an extraction hose. Technology at its best: Bare wire heating system that is insensitive to calcification Electronic control for constant hot water temperature Note: A 400 V power connection (three-phase alternating connection) is required to install this device. The assembly (water and electrical installation) as well as the initial commissioning and maintenance of this device may only be carried out by a qualified electrician in accordance with the applicable regulations and in accordance with these instructions. A three-phase AC connection (high power connection) is required to operate this device. For devices with a nominal output of more than 12kW, the consent of the respective network operator must be available or obtained before initial installation. The device may only be installed with the consent of the network operator by the network operator itself or by an installation company that is registered in the installer directory of a network operator.